VuQube VQ3000 Operations Instructions download pdf (Page 16)

Page 14

1. Turn on the TV and satellite receiver.

2. On the VuQube controller, press and hold the

ON button for 3 FULL SECONDS

The antenna will lock onto the appropriate satellites

before completing the search process.

ter the satellites have been located and the acquisition process is complete,

the st

atus light will be steady green.

3. On the receiver remote, press menu, 6, 1, 1.

4. Highlight Check Switch and press select.

5. Make sure Superdish and Alternate boxes

are NOT

selected.

6. Highlight Test and press Select.

The unit will perform a check switch test,

and the dish will periodically move back and forth.

(This process will take several minutes.)

Screen graphics may vary.

STEP 3: DISH AND EXPRESSVU CHECK SWITCH PROCEDURE

IMPORTANT! YOU MUST HA

VE COMPLETED THE ANTENNA

CONFIGURATION BEFORE RUNNING THE

CHECK SWITCH.

For automatic satellite switching, King Controls recommends using a Dish Network model

311 receiver for Dish 500, and a Dish Network model VIP211 or a VIP211k HDTV receiver for

Dish HD/HD Eastern Arc/HD Alternate. Do not use dual tuner receivers or recorders.

If you do not have a clear view of the satellites, the switch will not load.

Note: The SW21 and SW64 switches are a receiver software configuration that is loaded into the receiver after

running a check switch test with the dish locked on and configured for the appropriate service.

This one time procedure will not need to be repeated after successful installation, unless a) check switch

test is run again while connected to a home dish system, b) check switch is run when a receiver is not

connected, or c) you travel outside the coverage area of the pre-set satellite trio and switch trios (Dish

HD/HD Eastern Arc).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

VuQube VQ3000 Operations Instructions Page 16